Injector Clips, Fuel Pump… TURBO!!

Soooo I’ve been slacking on updates due to work but for an update Injector clips are now finished and the upper intake was put back on.

The warble 450lph was installed but ill be going back in to redo somethings,Then the FSR Turbo kit arrived and its installed as well!

I’ll post the pics and comments below.

Injector Clips:

1. See the white clip in the middle of the plug    

2. Get a pick/something with a fine point and pry it out

3. Be sure to pry it all the way out and set it aside.

4. Now you pry up on the locks inside to pull the wires

4. What it looks like when there are all pulled out

5. This point you can cut/splice the wire to replace the pin or whatever you’d like for the new clip

— This is how I wired mine… blue tape.. was just because.

6. Then all buttoned up! 

If anyone has any questions let me know!

 

As for the fuel pump.. it was really really straight forward

 

Turbo kit Install…

Man… I really wish I took my time but it was that SIMPLE lol

Which means all I have is a semi finished and finished haha

took a total of 2 hours to put in… 1 hour and 30 mins was spent clocking the turbo right and setting up the water lines

Leave a Reply